TC720 Type-C HD two-way switcher Use Manual

The TC720 Type-c two-way switcher allows you to connect two Type-c signal sources to a Type-c display, or to switch between one Type-c signal source and two Type-C displays. Supports 8K@60Hz,4K@120Hz,1080P@240Hz resolutions, gives you transfer rates up to 48Gbps, and is backward compatible with all previous Type-c standards.

Interface Display

Connection method:

• Two modes of operation: – Mode 1: Type-C Two in one out Connect two standard Type cables (Type-C1 and Type-C2) to the source device, such as a laptop, desktop, PC, and then connect one Type-C standard cable to the Type-C display. Press the “Select” button to switch between two signal source devices. – Mode 2: Type-C one in two out Connects a standard Type cable to the source device, such as a laptop, desktop phone, Nintendo switch, and then connects two Type-C displays with Type-C standard cables (Type-C 1 and TYPE-C c2). In this mode, the two monitors cannot be displayed at the same time, and you must press the “SELECT” button to switch between the two Type-c monitors.
• Note:

(1) The length of the standard cable connecting both ends of the product should not exceed 1.5 meters (the longer the line, the higher the line loss requirements).

(2) If you need to output 8K@60Hz,4K@120Hz, and 1080P@240Hz on your monitor through our products, please make sure that your Type-c source device, Type-c cable, and Type-c monitor support the resolution and refresh rate you require.

(3) Does not support automatic switching, can only be switched by the “SELECT” button.

(4) For some devices, when their Type-c port does not provide enough power, please connect the USB-C standard cable to your USB device.

(5) 8K Type-c standard cable must be used.

Product parameters:

Brand: AYINO

Model :TC720

Input/output interface :Type-C

Material: Aluminum alloy

Dimensions (L x W x H):53x59x9(mm)

Weight: 36g

Attention:

Please use the machine as listed instructions to maintain the long service life of the machine.

1. The machine should be placed away from humid, high temperature, dusty, corrosive and oxidizing environment.

2. All components will not be subjected to strong vibration, impact, fall.

3. Do not touch the power cable connector with wet hands.

4. Hold the power adapter head and do not pull the power cord when unplugging from the socket.

5. Turn off the power when you do not use the machine for a long time.

6. Do not open the lid or touch the internal parts.

7. Please use the original power adapter.

Before powering on the device, check the cable carefully. Make sure all interfaces are properly connected.